Ikea Lack stacked table with drawer for BambuLab etc.

Needed:
 

2x (or 3x) Ikea Lack Table 304.499.08 (or other color, if you like)
https://www.ikea.com/gb/en/p/lack-side-table-white-30449908/
and another 4 legs from table like this (so buy 3 tables, or go to “As-is”  discount area in ikea store, where sometimes you can find these legs alone, for ~1€ 

 

1x Ikea Komplement Tray 50 (this is for Pax series) 202.463.60 
https://www.ikea.com/gb/en/p/komplement-pull-out-tray-white-20246360/
Yes, this is not designed to work with Lack series, but… this tray is great for BambuLab X1 printer, and fits between Lack legs! Only drawback is guide rail - too wide for legs, but we can print new rail holders !
 

When you want to fit BambuLab X1 between two LackTables - you need additional 15cm in height (with this tray included) - so this is where we can make printed connectors, and add cuted additional legs. 

When printing - just make clone&mirror from parts, for another side. This is done in .3mf files 

Printed parts: 
4x LackTableJoiner (printed 4in1, with supports) - this are connectors for upper table legs, and 15cm cuted legs
2x RearLegs (printed 2in1, no support) 
2x rear guide mount (printed 2in1, one mirrored, supports) - this is the middle part, what holds tray to table.
2x FrontLegs_mount (printed 2in1, one mirrored, supports needed) - this is front rail guide mount, and legs mount, so every front leg should have a cut for railguide:

2x leg-cut-guide (printed 2in1, one mirrored) - this is template for cutting hole in front legs, for wider rails than legs dimmension. When you put this on leg - you can easly find what should be cut, to put leg on front mount. 


If you dont want see metal guide for tray - we have here nice cover for this ;) (print two, its slide like glove, you can use double side tape to secure it on rail guide). 

Warning -when you pull out the tray with printer on it - can flip over, because printer is too heavy, so whole table should be screwed to wall, or something! Be carefull!