Shampoo/Conditioner Bar Holder With Lid

This is a remix of Markus' "Soap Box for Shower" model, which was designed to hold shampoo and conditioner bars of a similar size to those sold by Lush. Changes that I made and my reasoning for them are as follows:

1. I didn't feel like gluing the spacer to the box, so I merged them into one model that can be printed with supports instead. I reduced the spacer height by 25% to make it more compact and save a bit of print time while retaining functionality.

2. The handmade bars sold by Etsy shops and similar are sometimes thicker than the Lush ones (which measure 60mm diameter x 21mm thick). Any bars around 22mm or thicker would prevent the lid from closing fully until the soap was worn down sufficiently. I made an alternative "deeper" holder which can accommodate bars up to 25mm thick, so users can now pick which is best for the specific products they tend to use.

3. I made a lid with a "C" for conditioner on it. Since I used a different font (Arial) than Markus, I also re-made the "S" lid to use for shampoo such that the fonts matched.

Print instructions

For shampoo/conditioner bars up to 60mm diameter x 21mm height, print the first model. Supports are required, touching buildplate only. No brim needed.

For bars up to 60mm diameter x 25mm height, print the "deeper" version. Supports are required, touching buildplate only. No brim needed.

Lids are interchangeable with both boxes. Attach with two M3x12 or M3x14 screws.

G-code contains the shallower box and a blank lid. Due to the inherent risks with downloading G-code from unknown sources, I always recommend downloading the models and slicing them yourself. I only upload G-code for the purposes of filling in the database info.