iSDT Q8 Charger and Parallel Adapter Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for holding the iSDT Q8 charger and parallel charging adapter as a single unit.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 380
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I love the iSDT Q8 charger. I also love having the parallel adapter to charge several batteries when I'm at a F5J contest. For a while I just dragged around these two with their cables hanging with one device hanging from the other. I realized that I could throw together something that worked better.
Enter this case. It is designed to hold the Q8 and the parallel charger board all in a single unit and provide a layer of additional protection. The case has ventilation holes for the Q8 and all the balance ports are easily accessible.
My suggestion is to print this out of a sturdy material. I chose to use Polymaker's PC filament. This allows me to leave the charger out in the sun or in the car without the worry of it deforming. Using ABS or PETG should also work as well.
For assembly all you'll need to do is put in the heat-set inserts. The holes for the inserts are designed for those that accept 3mm screws.