1 / 2
Umarex Notos Carbine Magazine holder PLUS+ — zdjęcie 1
1 / 2

Umarex Notos Carbine Magazine holder PLUS+

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This block will hold your magazines, shot tray, and fill probe so everything you need is with your Notos

Ocena
0 / 5
Polubienia
29
Pobrania
270
Wydruki
1
Wyświetlenia
1947
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

I have had great success making these of PLA with 3 perimeter walls and 20% fill. Print picc rail down with supports and you should be fine. You can also order them printed and with all the hardware installed at the targetforge.net website. You will need 3 .2" dia X 1/16" thick rare earth magnets and one each M4 SHCS w/hex nut. Magnets MUST be installed so they attract the ones on your magazines and single shot tray. How deeply you push the magnets into the block will affect how firmly the items are retained against the bottom of the pockets. You can also order them ready to go here:

https://targetforge.net/shop/ols/categories/umarex-notos-accessories

PS - To get the right fit for the probe storage area, you will need either a 7mm drill bit or reamer. The reamer makes the hole the perfect size and also make it super smooth inside. All the units I sell are reamed to maximize fill probe o-ring life.

 

Tagi