Skadis T-Nut using M2 heat-set inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A version of the Skadis T-Nuts using M2 heat-set inserts.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 206
- Wydruki
- 1
- Wyświetlenia
- 1513
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made my own version of Skadis T-Nuts, since I found M2 hex nuts to be too unreliable.
These T-Nuts are designed to fit heat-set inserts (M2) from the back.
- They can be inserted from the front and will lock themselves when tightened.
- Compatible with the “Skadis T-Nuts Mounting System” by 6d6178. Tag “skadisnut”.
- They print fine on a 0.4 & 0.6 mm nozzle (settings below).
Usability Tips:
When inserting the heat-set inserts, they may not be perfectly aligned. Also a small barrier of plastic may partially block the way to the threads.
In both cases I found it very helpful to just once fully screw in a screw from the back. Blocking plastic will be pushed out.
Print settings:
Filament: PLA
Layer height: 0.2 mm (0.4 nozzle) / 0.33 mm (0.6 nozzle)
Infill: 100%
Perimeters: 3
Support: not needed
Top/bottom fill pattern: monotonic lines
Top/bottom solid layers: 4/3
Design Origin
Full remodel, but heavily inspired by the original “Skadis T-Nuts Mounting System for Ikea Skadis Pegboards”.