1 / 1
Arduino Uno and Mega 2560 Stand with LCD and Breadboard Mounts — zdjęcie 1

Arduino Uno and Mega 2560 Stand with LCD and Breadboard Mounts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prototyping stand for Arduino Uno and Mega 2560 with spots to mount a 1602 LCD display and breadboard.

Ocena
4,625 / 5
Polubienia
148
Pobrania
1091
Wydruki
10
Wyświetlenia
4209
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

I needed a stand to mount my Arduino Mega 2560, a standard-sized 16x2 LCD display, and a full-sized breadboard. So, I whipped one up in Fusion 360.

Some notes:

  • While designed to fit the Mega 2560, the left four holes also allow mounting of a standard Arduino Uno board. The hole positions should be the same.
  • The holes are sized at 2.5mm, but often end up smaller than that. Depending on the screws used, you may need to enlarge these holes with a drill bit just a bit.
  • Screws I used to mount my boards: M3x6mm self-tapping or wood screws should do the trick.
  • To fit the breadboard into the tray, you'll need to clip off the small male breadboard connectors typically used to join multiple boards together. I did this purposely to avoid small bits and wires from getting stuck in there.

I've also provided STL, STEP, and Fusion 360 models for you to customize to your own needs.

Originally published on Thingiverse by me, migrated to Printables.

Tagi