DeWalt Battery Holder for IKEA SKÅDIS Pegboard

Remix of Ken226's model using 6d6178's T-Nut mounting system for IKEA SKÅDIS pegboards.  

Fits DeWalt 18v & 20v batteries.  May fit 10.8v, 14v, 24v, 36v, 40v, 54v & 60v batteries as I believe they have similar slide-in track tool interface systems; However I don't have those batteries on hand to test, so YMMV.  Let me know which ones work or do not work for those battery voltages and I'll adjust this description as needed.

I've included models with the voltage embossed for each of the listed above as well as a blank version.

More Info on the Skadis T-Nut Mounting System for IKEA SKÅDIS Pegboards

Please see 6d6178's post here:

https://www.printables.com/model/228663-skadis-t-nuts-mounting-system-for-ikea-skadis-pegb

And the SKÅDIS T-nut Collection with other compatible models here:

https://www.printables.com/social/105798-6d6178/collections/291558

Alignment Guides and Supports

There are two versions of each, dependent on which version will determine if supports are required.

• With Alignment Guides:    The alignment guide is incorporated into the model and thus will minimal supports for the alignment guides.
   
• Without alignment guides:  Requires printing of 6d6178's 2.5mm alignment guides included in the files sections. but can be printed without supports.

Required and Optional Hardware

• Required:
   
  • 2.5mm T-Nuts - See Files Area
  • 2.5mm Hex Nuts
  • 2.5mm Flat Head Cap Screw, recommend at least 18mm in length
     
• Optional:
  
  
  • 2.5mm Alignment Guides - Need depends on which version you printed

Print Settings:

Recommend 20% infill and at least 3 perimeters.

Other Notes

Recommend printing in PETG, although the print in the photo was printed in PLA and worked fine..

Can use 2.0mm mm fasteners and guides, but your milage may vary.