1 / 9
BambuLab X1C/P1P - Rise & Dry - Dry your filament while Printing! — zdjęcie 1
1 / 9

BambuLab X1C/P1P - Rise & Dry - Dry your filament while Printing!

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Rise the top of your Bambu and use that to hold and dry a 1kg filament spool. Compatible with X1C original top glass

Ocena
5 / 5
Polubienia
116
Pobrania
217
Wydruki
2
Wyświetlenia
6250
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

While printing technical materials the chamber temperature easily goes above 40/45degC, which is enough to dry some technical filaments (ABS, ASA, PETG, Silk PLA, etc), so instead of using an external filament dryer, why not use that heat to dry your next spool of filament? This was my concept.

These parts, obviously, should be printed in ABS and ASA, and some PETG can also handle the temperatures and strenght requirements.

By raising the top glass 90mm with 4 external pieces, and then printing aditionally 4 pieces that will support the spool (interlocked with a center cap screw) you're able to fit any 1kg spool and dry it while printing. The 4 support pieces are screwed to the external raiser using 25mm or bigger screws.

This riser is still compatible with original Bambu X1C Top Glass.

 

Compatible spools (99% compatibility).

External diameter LESS than 210mm

Internal diameter MORE than 30mm

Thickness LESS than 80mm

 

If you have any ideas or feedback for improvement, comment bellow.

Tagi