AnyCubic Kossel BLTouch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Removable mount for a BLTouch on a (slightly modified) AnyCubic Kossel
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 32
- Wydruki
- 1
- Wyświetlenia
- 455
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is a removable mount for a (slightly modified) AnyCubic Kossel.
The mount clips onto the end effector and holds a BLTouch underneath for delta calibration and mesh bed levelling. Two M3x5mm screws self tap into the under-size holes in the mount to attach the BLTouch.
The Fusion 360 model can be downloaded (and hence customised) here: https://a360.co/2KeeqeZ
The Z-Offset for me was 49.50mm, but I have modified my Kossel with an E3D V6 hotend which sits higher up than the stock hotend.
I recommend measuring your offset as it will vary. The M114 (reports current XYZ) command is useful for this.
Print Settings
If bed leveling is bad, use a raft. This model is really not fussy with print settings. Will need support though.
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
20%