AnyCubic Kossel BLTouch Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Removable mount for a BLTouch on a (slightly modified) AnyCubic Kossel
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 32
- Makes
- 1
- Views
- 455
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
This is a removable mount for a (slightly modified) AnyCubic Kossel.
The mount clips onto the end effector and holds a BLTouch underneath for delta calibration and mesh bed levelling. Two M3x5mm screws self tap into the under-size holes in the mount to attach the BLTouch.
The Fusion 360 model can be downloaded (and hence customised) here: https://a360.co/2KeeqeZ
The Z-Offset for me was 49.50mm, but I have modified my Kossel with an E3D V6 hotend which sits higher up than the stock hotend.
I recommend measuring your offset as it will vary. The M114 (reports current XYZ) command is useful for this.
Print Settings
If bed leveling is bad, use a raft. This model is really not fussy with print settings. Will need support though.
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
20%