Improved Ender 5 S1 Cover with CR-mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Kushmakers hotend cover with CR-touch mount based on Kevin Coopers original design, now easier to print in ABS
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 217
- Wydruki
- 0
- Wyświetlenia
- 1950
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The design I remixed is good but it required too many supports to print on it's side and it had a small surface on the top which results in low adhesion that almost prevented me from printing it in ABS. It also saves on material as it only required about 26g of ABS including supports, however this design does way more than the one I remixed which can be relevant for some
This design is only slightly altered from the original but the added material to the top makes it possible to print standing up like the original cover made by Kevin Cooper. Huge thanks to Kushmaker for coming up with the idea.
I bought the 5Pin 15cm version of the cabled listed bellow which allowed me to route the cable up and over the gantry so I can tie it in securely so it won't mode when running input shaper. I strongly suggest routing the cable this way
AliExpress JST1.25 ribbon cable
Alternate link as old one no longer works
New probe offset after installation:
X= -45.0mm
Y= 0.0mm