1 / 2
Magnet Orientation Block / Jig for 10x1, 8x3, 6x3 — zdjęcie 1
1 / 2

Magnet Orientation Block / Jig for 10x1, 8x3, 6x3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnet Orientation Block to help keep magnets in a consistent orientation

Ocena
0 / 5
Polubienia
1
Pobrania
20
Wydruki
0
Wyświetlenia
238
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

I was assembling Pirulk's Wingspan Insert and needed to place a small ton of magnets. I'd discovered while assembling my Wingspan Dice Tower prints that getting consistent magnet orientation is critical.

So I designed this jig to hold the three kinds of magnets I commonly use. I then printed two of these. In one jig, I have all of the magnets in one orientation and in the other jig, they are in the reverse orientation. (Yes, I could do this with one jig, but I found flipping the magnet upside down after removing it from the jig was awkward and making a second jig is trivial.)

Parameterized Fusion 360 export included.

Note that my photos represent a previous version of this jig. In the current version, the text is larger and the middle one is now 8x3 instead of 8x2.7.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

No

Resolution:

0.3mm

Infill:

15%

Filament: Hatchbox PLA White, Light Blue Post-Printing =============

I used CA glue to affix the magnets to the jig, being careful they were all in the same magnetic orientation.

How I Designed This

I measured my magnets and drew it up using User Parameters and a design timeline in Fusion 360. Feel free to download the source document if you have differently sized magnets.

Category: Hand Tools

Tagi