Desk edge cable roller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why not over-engineer routing a cable over a desk edge?
- Ocena
- 3 / 5
- Polubienia
- 71
- Pobrania
- 109
- Wydruki
- 0
- Wyświetlenia
- 3155
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted something to route a cable along a desk edge without damaging the cable in the long run.
Didn't find anything that suits my needs so I designed this contraption.
Maybe someone finds it useful.
===================================
Someone on Reddit asked for an alternate mounting option.
Your wish is my command.
Print it on its side with tree supports and brim enabled.
===================================
Use two 608 bearings and any 608 bearing guide.
I used the guide from this model: https://www.printables.com/model/179627-filament-guide-screw-mounted-608-bearing
To secure the long roller to the top use any M3 screws.
I also used this cable stop at the bottom so I don't jank the cable out of its wall plug: https://www.printables.com/model/407391-cable-stop
I printed it in the orientation shown in the pictures.
Not ideal, but works.
Here it is in action: https://youtube.com/shorts/fSgbJLltTe0
The distance between the two pins is parametric and can be changed in Fusion360.