Customizable Wall Mount for Mobile Hotspot / Wifi Access Point / Router (screws or glue pads, TP-Link, Huawei, Alcatel..)

This is a screwable or gluable wall mount for mobile LTE / 5G wifi hotspots / access points with an additional slot for the battery. 

Features:

• charging slot in the middle on the bottom
• display is visible (turn device around if you don't like it)
• extra slot to store the battery for 24/7 USB DC operation 
• use 2 screws or glue pads
• optional: 2 universal cable guides (left and right to the battery slot)

Currently I support the following models:

• TP-Link:
  • M7450 ✔ (device: 112.5x67x16mm, battery: 78x58x5mm)
  • M7650 (device: 112.5x67x16mm, battery: 78x58x5mm)

Please uploads your Makes with the device and the battery in the slots so I can verify ✔ the correct dimensions.

I can easily customize it, if you give me the dimensions for your device. I will do this for you until I'm ready to release all the files. I need the following exact dimensions in milimeters (do not rely on the manufacturers datasheet):

• Device:
  • Width
  • Height
  • Depth
• Battery:
  • Width
  • Height
  • Depth
• Optional:
  • wall thickness (default: 1.8 mm)
  • leeway (default: 0.9 mm all dimensions)
  • space for charging cable (default: 10 mm diameter)
  • screw holes (default: 3.8 mm diameter)

To Do:

• customizable slots for other connectors (antennas etc.) that are not in the middle of the bottom

Unfortunalty I only learned afterwards, that the TP-Link Models M7x50 do not support USB-only operation mode without the battery inserted. 

Easy print in upright position, use a 5-10mm brim if your material tends to warp (like ABS/ASA for useage in vehicles).