Mesh fan grills & fan support, Voron V2 & VT
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Couldn't find any "clean" mods for adding mesh to the middle fan support, so i made this.
- Ocena
- 5 / 5
- Polubienia
- 63
- Pobrania
- 246
- Wydruki
- 2
- Wyświetlenia
- 1468
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Middle Fan Support with mesh
The mesh parts are made to snap in, but i added a tiny drop of CA-glue on the backside in some spots to make sure they stay in place.
Print the mesh with 0 bottom/top layers, 2 perimeters & 20% honeycomb infill. You will most likely need to tweak the infill angle to make the "points" of the hexagons point upwards (usually 0 or 90 degrees). (I also found that the side printed downwards/towards the texuted PEI gave the best look on the fan mesh/black).
For a reference to how to do the mesh part look at Eddies clip from 6:20.
- - -
In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!