Cloud Gate aka "The Bean" Ornament
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of a model of the Cloud Gate aka "The Bean" in order to convert it into a holiday ornament!
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 438
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the Cloud Gate aka "The Bean" model. I reduced the scaling of the original model and added a sturdy loop on top so you can hang it as an ornament!
Highly recommend painting it with this paint afterwards to get that true 'bean' look: https://www.culturehustleusa.com/collections/potions/products/mirror
Print Notes
Should use a 0.4mm nozzle or smaller. Infill shouldn't need to be too high, but I would recommend a gyroid or cubic pattern to get that x + y + z strength, as well as connecting infill lines.
Definitely need supports for this one, I would recommend keeping infill down so you can also keep the support density lower - that way you have less postprocessing after removing the supports.
Post-Processing
You are probably going to want to sand and prime it a few times with increasingly fine-grain sandpaper after removing the supports. Primer will help fill in gaps. This is especially necessary if you are planning to paint it with anything reflective.