EOS2 Mobula7 canopy (should fit any "whoop" style quad)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EOS2 Mobula7 canopy (should fit any "whoop" style quad) Should fit any camera with the same mounting width of 14mm
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 111
- Wydruki
- 0
- Wyświetlenia
- 604
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I broke the HappyModel EOS2 canopy that I purchased, the screws ripped right out of screw holes, also the camera angle would change every time someone sneezed in my house so I figured it was time to design a new one.
I did design this so that the screws with the big heads that come with the Mobula7 replacement FC and the UR65 fit this canopy.
lol it seems like I get better and better with each new canopy I design.
WARNING!!! I do use the HappyModel Whoop VTX so I did not have to really worry about the VTX fitting so if you are using a different type of VTX it may have space limitation issues, it SHOULD work just fine with a beta6/75x vtx to use with the EOS2.
In the picture where there is a red canopy and a clear canopy the red one is printed in PETG the clear one is TPU.
It comes in at 2.8 grams.
I print at 0.1mm layer height, infill doesn't matter as it is just 2 perimeters, and support.
If printing TPU then turn off retraction, TPU doesn't really like retractions being on.
Have fun and happy flying.