Longer LK5 Pro Dual Blower 5015 upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After installing Klipper and seeing how quick it was possible to print, I decided to upgrade the cooling significantly!
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 1130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
So, long story short, I installed Klipper on my SKR2 board (I was running Marlin) and noticed the stock 4010 fans were not going to cut it with the speeds I was capable of printing. I decided to pick up a set of 5015 blowers and went to work designing a new mount for everything.
The new mount provides the ability to mount two 5015 blower fans, the stock hot end fan, BL-Touch as well as an ADXL345 mount on top. The amount of increased part cooling is rather insane.
This was designed with my setup in mind, which is:
- LK5 Pro, Dual Blower setup (this will NOT fit the single fan version as the mounting holes are different)
- Phaetus BMS hotend - The cooling ducts may need to be raised or lowered if you have a different setup.
- BL-Touch - My offset came in at just over 2.00mm (for Z). (x_offset: 0, y_offset: -37)
- ADXL345 mount included at the very top.
- Direct Drive conversion, which shouldn't matter.
It's not super pretty, but it works great!
I printed in Black PLA+ with 3 perimeters, 25% honeycomb infill, 0.16 layer height.