Longer LK5 Pro Dual Blower 5015 upgrade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
After installing Klipper and seeing how quick it was possible to print, I decided to upgrade the cooling significantly!
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 92
- Makes
- 0
- Views
- 1,130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
So, long story short, I installed Klipper on my SKR2 board (I was running Marlin) and noticed the stock 4010 fans were not going to cut it with the speeds I was capable of printing. I decided to pick up a set of 5015 blowers and went to work designing a new mount for everything.
The new mount provides the ability to mount two 5015 blower fans, the stock hot end fan, BL-Touch as well as an ADXL345 mount on top. The amount of increased part cooling is rather insane.
This was designed with my setup in mind, which is:
- LK5 Pro, Dual Blower setup (this will NOT fit the single fan version as the mounting holes are different)
- Phaetus BMS hotend - The cooling ducts may need to be raised or lowered if you have a different setup.
- BL-Touch - My offset came in at just over 2.00mm (for Z). (x_offset: 0, y_offset: -37)
- ADXL345 mount included at the very top.
- Direct Drive conversion, which shouldn't matter.
It's not super pretty, but it works great!
I printed in Black PLA+ with 3 perimeters, 25% honeycomb infill, 0.16 layer height.