A1200 Back Trap Door MicroHDMI/HDMI, microSD extender slot and RJ45

Modified back trap door with slots for MicroHDMI/HDMI and RJ45.

Also made an opening for pulling a microsd extension out of the computer (Micro SD Memory Card Slot to TF Card Extender Cable Extension)

If you use the HDMI version, you must screw on the top screw after the trap door is put in place.

You could also take a look at this HDMI version: https://www.thingiverse.com/thing:4593132

Recommended (micro)hdmi cable lenght is 20 cm.

Screws: Two M2x5mm for the HDMI, One M2x10mm for the ENC28J60 Ethernet Module LAN

Get some flat ribbon cable for the network module, and remove the top at one end or else it will be touching the floppy drive. See pictures for description. https://www.ebay.com/itm/10pcs-10pin-2-54mm-IDC-Flat-Ribbon-Cable-Wire-for-Atmel-AVR-ISP-JTAG-DownNWUSHH/303636924114?hash=item46b22bc6d2:g:DEwAAOSwfLxbEfQf

Used on Amiga 1200 with a Vampire 1200 accelerator.

Use it together with my other designs to hold the sd card extender: https://www.thingiverse.com/thing:4563129

or https://www.thingiverse.com/thing:4578398

A version without the microsd slot is here: https://www.thingiverse.com/thing:4557964

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2 mm

Infill:

Notes:

No support needed, but you could use a little under the RJ45 part for best result.

Category: Computer