EBB CW2 cable bridge for drag chain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternate model with a drag chain attachment for Switchwire and Stealthburner
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 299
- Wydruki
- 0
- Wyświetlenia
- 1576
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Remix to add a drag chain mount. For Switchwire with EBB SB2240_2209 CAN bus adapter, specifically to allow a drag chain for use with Beacon bed probe rather than umbilical. This is a new mix that has not been tested yet!
There are two versions: one for 3-hole 7mm x 8mm spacing, and one for 2-hole 8mm spacing.
I'm building a Switchwire with the BigTreeTech SB2209 CAN Bus and U2C. My bed level sensor will either be KlickyNG or Beacon, making the umbilical attachment really awkward My plan is to loop the CAN bus cable (along with Klick servo wire or Beacon USB) into the entry of the drag chain. I'm considering a zip tie tie-down if the cables tend to move at all. That's the plan! I'll post pics and any additional models when I get it worked out (mid-May 2023).
Edit/update: I finished my Switchwire this weekend. The part was perfect. I used the OEM part for the CAN bus that holds the cable, an twisted the cable to form a loop to reduce strain (see pic)
