1 / 2
Voron 0.1/0.2 MiniSB for Orbiter 2.0 and PINDA sensor — zdjęcie 1
1 / 2

Voron 0.1/0.2 MiniSB for Orbiter 2.0 and PINDA sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adding a PINDA sensor without loosing print area

Ocena
0 / 5
Polubienia
27
Pobrania
123
Wydruki
0
Wyświetlenia
2216
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is the Cowling for the Mini Stealthburner on a Voron 0.1 or 0.2 with an added slot for the PINDA sensor.

So you can enable probing on the Voron0 >> You will not loose any print area, as the pinda sensor is now located on the back below the X-axis extrusion.

Please be aware: I used a modified X-Axis with MGN9. please always check the clearances before taking the printer into action!

A sample Klipper configuration would be:

[probe]
#Inductive Probe
pin: sht36:PC15
x_offset: 20.5
y_offset: 17.5
#z_offset: 0
speed: 2.0
samples: 3
samples_result: median
sample_retract_dist: 1.0
samples_tolerance: 0.05
samples_tolerance_retries: 3

>> The Z-Offset has to be calibrated!

You can fix the PINDA Probe with a M3x10 screw and M3 hex nut.

The model is based on the version from Zachary Edes, but I modified it, that you can use standard hotend inserts (like for Dragon or Bambu). I also added the possibility to fix the wiring with zip ties like on the original one.

Tagi