Ender 3 S1 Display-Mount (front right screws)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After trial and error i finally found the design im happy with, tought I would share it with you. Read the description!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 433
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
HI!
Designed to be close to zero clearance between both buildplate and drawer. Raised the display-angle from 25 to 45 degrees so its viewable from overhead and from a distance.
Excuse my sloppy print tho, this is the 4th prototype, so its printed with 0.8 nozzle/0.4 layerheight/0.85Layerwidth at high speed.
Its made to print without any supports, just standing up with a 250mm brim.
2pcs M5x30 is needed.
Pro tip: The angle is 45 degrees on the back side, if you have the stock fan/duct that only blows from the front, turn the model 180 degrees so that the overhang is facing forward. Allows you to print it faster.
PLA was used for this prototype.
If you have any questions, leave a message.
Thanks