Wrist lockable stripe / Event entrance plastic bracelet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Put it on once on your hand, don't take it off again...
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 401
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
Possibilities of use:
- Event entrance evidence
- VIP selection
- Warranty seal
- Many others purposes
- Animal label
Attention, when you putting it on, it can damages the skin! Be careful! Use at your own risk.
It takes a bit of skill to you be able put the bracelet on. But it was tested and is functional.
Use only PET-G material, PLA doesn't work.
If you don't have a very precisely calibrated printer, you may find that the end won't fit. Then you will either have to calibrate your printer or enlarge the hole in the housing a bit. For this you can use Tinkercad for example.
Recommendation:
PET-G, 0,2 mm layer width, slow print, seam position: align, infill: 100 %
Printing time: under 30 min.
