Wrist lockable stripe / Event entrance plastic bracelet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Put it on once on your hand, don't take it off again...
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 38
- Makes
- 0
- Views
- 401
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
Possibilities of use:
- Event entrance evidence
- VIP selection
- Warranty seal
- Many others purposes
- Animal label
Attention, when you putting it on, it can damages the skin! Be careful! Use at your own risk.
It takes a bit of skill to you be able put the bracelet on. But it was tested and is functional.
Use only PET-G material, PLA doesn't work.
If you don't have a very precisely calibrated printer, you may find that the end won't fit. Then you will either have to calibrate your printer or enlarge the hole in the housing a bit. For this you can use Tinkercad for example.
Recommendation:
PET-G, 0,2 mm layer width, slow print, seam position: align, infill: 100 %
Printing time: under 30 min.
