Cat Magnet Earrings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cat magnet earrings. Clip them on your ear lobe, or just use them as fridge magnets!
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 391
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Cat magnet earrings. Clip them on your ear lobe, or just use them as fridge magnets!
The model file only contains one half, so you either need to print two per ear (if you want the cat on both sides of each ear) or one per ear (if you want a bare magnet on the back side and cat on front).
You will need 15x2mm sized magnets. Superglue the magnet into the hole after printing. Be careful to get the magnet polarity correct if you want two pieces to connect on either side of your ear lobe.
For extra bonus points, draw some cute little eyes and whiskers on the front!
Settings as shown:
Material: Amazon Basics White TPU (I used TPU, but that isn't necessary. PLA should work just fine.)
Layer height: 0.2mm
No supports needed. Orient the hole side upward.
If you have a different sized magnet, leave a comment and I might add some variations!
This design was inspired by Cat Ring by Preischl 3D, so shout out to them!