DIN Rail Bracket Redux
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric redesign of Fabian's DIN rail bracket model including selftap, heatset, and print in place variants.
- Ocena
- 4,9 / 5
- Polubienia
- 257
- Pobrania
- 1879
- Wydruki
- 13
- Wyświetlenia
- 6976
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- BSD License
Well, I did it again. What began as a simple remix turned into a week-long project. Long story short I was trying to do a relatively simple remix but ran into issues with some oddities in the original model (example: a 10μm triangular cut made it impossible to adjust some chamfers), so I recreated it from scratch while maintaining full backward compatibility. My hope is that remixing this model will be significantly easier than the original.
For now, there are three variants:
- Selftap: based on Fabian's original design, with holes sized to mesh with M3 threads. I added some chamfers to make it easier to get the screws started.
- Heatset: accepts common “Voron size” M3x5x4 brass inserts. Use this if you need to be able to remove the clip easily.
- Unibody: this version is practically useless on its own (unless you want to glue something to it), but can be used as a base for other designs.
The selftap and heatset variants have the same hole spacing as Fabian's design (51mm), allowing either to be used with remixes of the original.
Parameters
| Parameter | Value | Description |
|---|---|---|
| chamfer | 0.4mm | Global edge chamfer |
| selftap_hole | 2.8mm | Selftap hole diameter |
| heatset_hole | 4.6mm | Heatset hole diameter |
| heatset_height | 5.0mm | Heatset insert height |
| closed_width | 34mm | Distance between the fixed and moving spring ends when not attached to a DIN rail |
| slide_clearance | 02mm | Clearance for slides to hold spring block in place |
| spring_width | 1.6mm | Thickness of the spring used to grip the DIN rail |
| spring_radius | 0.4mm | Inner radius of the spring (controls pitch) |
Changelog
| Date | Changes |
|---|---|
| 2023-06-27 | Add 4.2mm heatset variant |
| 2023-07-05 | Add reversed variant that allows screws to be inserted from behind; Upload 3mf files for individual clips |
| 2023-11-25 | Add unibody-simple and unibody-short variants |