Ender S1 and S1 Pro X gantry light bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Light bar for the ender s1/ s1 pro
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 123
- Wydruki
- 0
- Wyświetlenia
- 1323
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Ender s1 gantry light bar. im sure it will work on a pro. Screws right into the existing hex screws on the back of the gantry.
I used a 24v led strip and soldered - and + wires and ran it into the black loom right at the clip on the Z rod. Then ran it to the power supply - and +. Added a rocker switch to the front bezel. If installing the rocker switch in the same location that i used. try installing it as high as possible because the connector on the mother board was almost in the way. I had to bend the tabs on the rocker switch up.
please leave ⭐ review and rate.
Buy me a some raman if i helped you out in anyway.
Check out my other designs.