Ender S1 and S1 Pro X gantry light bar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Light bar for the ender s1/ s1 pro
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 123
- Makes
- 0
- Views
- 1,323
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Ender s1 gantry light bar. im sure it will work on a pro. Screws right into the existing hex screws on the back of the gantry.
I used a 24v led strip and soldered - and + wires and ran it into the black loom right at the clip on the Z rod. Then ran it to the power supply - and +. Added a rocker switch to the front bezel. If installing the rocker switch in the same location that i used. try installing it as high as possible because the connector on the mother board was almost in the way. I had to bend the tabs on the rocker switch up.
please leave ⭐ review and rate.
Buy me a some raman if i helped you out in anyway.
Check out my other designs.