Nerf Caliburn Pic Rail Talon Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I don't want to use a belt, so I made a mag holder for talons on my Caliburn! It prints a bit loose, so change your…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
I don't want to use a belt, so I made a mag holder for talons on my Caliburn! It prints a bit loose, so change your slicer and adjust the scale just a bit (like 0.5-1%) to accommodate. Should be a friction fit for both mounting to the blaster and the magazine itself. I used electrical tape to give a bit of friction, but different printers will print differently.
I am still updating this, so if you have feedback, let me know! Enjoy!
UPDATE: 7/13/2020 - Made the two holes that were designed for 6-32 Screws. Also added a raised ridge on the bottom support for the mag, allowing a tighter fit.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.2-0.8
Infill:
20-80
Filament: Hatchbox PLA Black
Category: Sport & Outdoors