Air 2S Propeller Case

The slimline design keeps the props easily accessible.

To stow in the case; the propellers are folded, placed in the correct mount (CW or CCW) and then rotated down and held in place by the bump clip.

To remove from the case; push gently through the opening at the back and push up, rotate the propeller vertically and then the propeller can come away from the case.
IMPORTANT: There is a distinct model for each prop orientation - Counter-Clockwise and Clockwise. Note the 'circle' indicator on the Counter-Clockwise model.

Steps on how to use the case (Mavic 2 Props shown)...

Compatibility

This has been tested with the DJI Air 2S (7238 Low-Noise Propellers).

• DJI Air 2S
• Mavic Air 2

Features

• Unique minimalist design
• Easy storage and release system

If anyone finds any problems (dimensionally or otherwise) post them up, so I can get the fix model.

Instructions

• All parts should orientate correctly on slicer plate
• After printing, check it operates correctly
• IMPORTANT Correctly match case to propeller as there are different mounts depending on if it's Clockwise (CW) or Counterclockwise (CCW)
• The indicator for CCW Mount is a raised circle and CW mount is without this.
• This was printed in PLA but PETG will be fine. I have had modest success printing in TPG also, but find the hard plastics better overall.
• After printing, check the surface of the case is smooth for the propeller to slide against.

EXPERIMENTAL DESIGN

This model has been designed for a specific usecase, it has not yet undergone extensive testing. Constructive feedback is appreciated.

Propeller Cases Available for...

• Mavic 2 Low-Noise Propeller Case | Thingiverse | Printables | Cults 3D
• Mavic 3 Propeller Case | Thingiverse | Printables | Cults 3D
• Air 2S Propeller Case | Thingiverse | Printables | Cults 3D

Print Settings

Walls: 3 or 4 lines

Infill: 15%

Rafts: No

Brim (Optional): 3 - 5mm

Supports: No

Resolution: 0.2mm or better

Notes: Printable using PLA or PETG or even TPU