BetaFPV Pro75 to 16x16mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter plate allows you to mount any 16x16mm ESC/FC, such as tinyfish FC, on the BetaFPV Pro75 frame. If you…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 386
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This adapter plate allows you to mount any 16x16mm ESC/FC, such as tinyfish FC, on the BetaFPV Pro75 frame. If you print this thing using a flexible material, e.g. TPU, it will probably also work as a softmount (i still have to see about that). It is designed, so that you can screw the adapter down where you'd normally screv down the BetaFPV FC (or Beebrain, etc...). However, printing it in TPU provides such a tight fit, that screwing down is not necessary to hold it in place.
I added a cm275t camera mount. I took flexrc's design (https://www.thingiverse.com/thing:2765436) and made the whole thing a little bit lower and reduced the camera angle from 25 to 15 degrees, which for me is enough in a tiny whoop style aircraft.
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 2
Rafts:
No
Supports:
No
Infill:
10%
Category: R/C Vehicles