1 / 10
CR-10 FANG W/ BLtouch (Micro Swiss Direct Drive) — zdjęcie 1
1 / 10

CR-10 FANG W/ BLtouch (Micro Swiss Direct Drive)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

EDIT 2/18/2020 Added wire guide to support clip (v3) If you have already printed this you can either drill a 3mm hole…

Ocena
0 / 5
Polubienia
0
Pobrania
14
Wydruki
0
Wyświetlenia
173
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

EDIT 2/18/2020 Added wire guide to support clip (v3) If you have already printed this you can either drill a 3mm hole in the original base or just leave it. Seems stable enough without the extra screw


Fang mount for Micro Swiss Direct Drive

This base is for the micro swiss hot end

You will need to print the fan and 40mm fan duct from https://www.thingiverse.com/thing:2763931

I ended up needing t m3 nuts as spacers for the bltouch. I added a washer for good measure. All in all it is performing well

x_offset: -40

y_offset: -10

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Doesn't Matter

Supports:

No

Resolution:

.2

Infill:

30%

Filament: Overture PETG Orange

Category: 3D Printer Parts

Tagi