Solar Hat Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to fit the motor, fan, and solar cells from the Amazon item KingBra Summer Sport Outdoor Hat Cap with Solar…
- Ocena
- 0 / 5
- Polubienia
- 125
- Pobrania
- 141
- Wydruki
- 0
- Wyświetlenia
- 8379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Summer
- Licencja
- Creative Commons — Public Domain
Designed to fit the motor, fan, and solar cells from the Amazon item KingBra Summer Sport Outdoor Hat Cap with Solar Sun Power Cool Fan for Cycling.
After 3d scanning a hat with Photogrammety (used my cell phone + AGI Metashapes) I designed this in Rhino 6. I placed patterned tape on the hat face during the photo process, to give the algorithm more pattern match points.
I chose to solder new wires, and place heat shrink tubing. This is not required, there should be ample room for the excess wire, underneath the fan inlet cowling.
I also chose to paint the fan black, so it does not draw more attention. It is barely visible inside the inlet cowling.
Print instructions
Must be printed with supports. Print in material which will not soften under direct sunlight (I chose PETg).
The included Gcode file is:
- Prusa MK3/S Firmware version 3.7.2
- Temps for PET/PETg
- 0.15 Speed profile, 150 travel, 50 perimeter
- Supports from Build Plate with Z contact of 0.15mm