1 / 3
Fillamentum NonOilen profile (Beta) for Bambu Lab X1C — zdjęcie 1
1 / 3

Fillamentum NonOilen profile (Beta) for Bambu Lab X1C

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Unofficial material profile for Bambu Lab Studio or Orca Slicer prepared and tested on Bambu Lab X1 Carbon 3D printer.

Ocena
5 / 5
Polubienia
17
Pobrania
176
Wydruki
0
Wyświetlenia
1181
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Neither Bambu Lab Studio nor Orca Slicer contain a material profile for Fillamentum NonOilen, a great 100% recyclable material. (More info about this material here.)

► I have prepared a material profile based on PLA and for use on Bambu Lab X1 Carbon with AMS (material station) and 0.4mm nozzle using Calibration procedures in Orca Slicer:

  • Temperatures are reduced (NonOilen needs to be printed lower than PLA to avoid degradation!). 
  • Max. volumetric speed is also reduced (however, I welcome further experiments here).
  • I left the bed temperatures as for PLA, it depends on your treatment (I print on Cold plate with 3DLAC spray). 
  • The Flow ratio for me did not need to be changed against PLA (both calibrations from Orca Slicer sit at 0.98). 
  • Pressure advance is slightly changed (to 0.01). 
  • For the material density I base it on the manufacturer's datasheet (1.05 g/cm3). 
  • The rest is left as for Generic PLA for V1.

Use at your discretion, I welcome your practical experience with NonOilen.  

Tip: Make sure to turn off Flow calibration before the start of printing on Bambu Lab X1C unless you want it to overwrite this profile values.

Tagi