Sovol SV06 BTT Manta M5P controller box -remix-

This is a remix of https://www.printables.com/model/426252-big-tree-tech-manta-m5p-case-v02 by Raziel's M5P controller box for the BTT Manta M5P MCU.  I added the stock mounting bracket holes to the main box and increased the top umbilical hole to allow the ribbon cable passthru.  I am going to create a strain relieve bracket to snap into place to further tie it all in, in another model.  (also including the 12mm umbilical version)

Tolerances on the M5P mounting a tight, you may have to sand the right hand side of the hole the ethernet port sits in about .25 to .5 mm if that.  what I found is if you sand that right side just a hair, and when you place the board in you put the left front corner of the M5P in that little curved cutout first, then square it into place after sanding that side of the ethernet square cutout the mounting holes should be pretty close.  I chose to put heatset inserts in but if you do not, you should be able to thread m3s into the mounting holes just fine.  I did not alter any of the other cutouts and all the ports aligned spot on.

I may revise that model to provide a slight curved cutout at the micro SD card slot to make it easer to pull the SD card out, there is very little edge to grab it, I ended up using a tiny flathead to get the card out.  I will make a revision and will update, I may also adjust the ethernet port as well.  

Use this model I edited to mount the box to your SV06.

https://www.printables.com/model/482111-sovol-sv06-btt-manta-m5p-controller-adapted-frame-