Simple Rear Wire Holder SW-200
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just a simple wire holder for the extruder and hotend wires that come out the back of the Sooway SW-200 and…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is just a simple wire holder for the extruder and hotend wires that come out the back of the Sooway SW-200 and similar 3d printers.
I've noticed these wires sometimes get caught on the left rear bed adjustment knob and can cause it to come loose during a print if the wires get pulled up too high.
This holder prevents that, without restricting the z-axis movement, and also allows the wires to be unclipped from it easily in case you need to remove the entire z-axis assembly.
It simply screws onto the z-axis motor plate as pictured.
Enjoy!!! ^_^
Print Settings
Printer:
Sooway SW-200
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.4
Infill:
100
Filament:
ColorCubed ABSBlack
Notes:
This might work fine printed in PLA provided your z-axis motor isn't running too hot.
You may need to drill out the screw hole slightly.There should be a wide enough gap between the motor and the wire holder to just slide the wires in and out of the holder.
Category: 3D Printer Accessories