Simple Rear Wire Holder SW-200
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is just a simple wire holder for the extruder and hotend wires that come out the back of the Sooway SW-200 and…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 15
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is just a simple wire holder for the extruder and hotend wires that come out the back of the Sooway SW-200 and similar 3d printers.
I've noticed these wires sometimes get caught on the left rear bed adjustment knob and can cause it to come loose during a print if the wires get pulled up too high.
This holder prevents that, without restricting the z-axis movement, and also allows the wires to be unclipped from it easily in case you need to remove the entire z-axis assembly.
It simply screws onto the z-axis motor plate as pictured.
Enjoy!!! ^_^
Print Settings
Printer:
Sooway SW-200
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.4
Infill:
100
Filament:
ColorCubed ABSBlack
Notes:
This might work fine printed in PLA provided your z-axis motor isn't running too hot.
You may need to drill out the screw hole slightly.There should be a wide enough gap between the motor and the wire holder to just slide the wires in and out of the holder.
Category: 3D Printer Accessories