UCTRONICS Pi Rack mount adapter for HDHomeRun CONNECT DUO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount allows you to install a HDHomeRun tuner in one bay of a UCTRONICS Pi Rack.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 849
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
I created this adapter to allow me to mount a HDHomeRun CONNECT Duo TV tuner in a spare bay of my UCTRONICS Pi Rack. There is a small retaining tab that keeps the tuner from sliding out once it's installed. I added vent holes on top/bottom because the tuner gets somewhat warm while streaming and I wanted to make sure it did not overheat.
You will need two M3 captive panel screws. I used PFS32-M3-30(16) that I found on AliExpress. These screws match the panel screws that are used in the other bays of the Pi Rack. You'll have to heat them up with a soldering iron and press them into the plastic. This works well (don't burn your fingers!)
I printed with Prusament Jet Black PETG and enabled supports on the build plate only. The vent holes do not need support.