Sovol SV06 Plus adjustable CR BL touch mount volcano/stock nozzle

This is an adjustable CR Touch / BL Touch mount for Sovol SV06 Plus only.

To pair with adjustable Vortex shrouds for Plus - to be able to use both, stock proprietary or volcano style nozzles - there's a difference in their length. My mount will fit next to the Vortex fan's pretty wide port, leaving enough gap. If you are using a different shroud it should be ok as well, but please double check it.
https://www.printables.com/model/452216-sv06-plus-vortex-v2-adjustable-cooling-led-system

Mount comes in 2 parts - main body that's got adjustment on bolts, which is capable of moving up/down by 2.5mm, which is difference in lengths of volcano and stock proprietary nozzle of SV06 Plus. The 2nd part is a spacer, to make it easier to feed bolts through holes - at correct height the bottom bracket hole would be partially covered by hole to attach CR/BL touch, so first you attach the main body to the extruder, then you attach the spacer & probe to it. To attach the main body to the extruder you can use stock screws from the induction probe, for rest you need parts as below.

Required parts:

• obviously CR/BL touch probe with correct wire with JST 1.25 plugs on both ends to replace stock induction probe (pre-made wire can be purchased here for example https://www.aliexpress.com/item/1005004869477858.html it's got all 5 wires that are required by CR/BL probe)
• 2x M3 heat insert threads to attach probe to main body
• 2x M3 12mm(thread length must be 10+mm) screws of any type

Offset and type of your probe will be different from the original induction probe, so you must change it in your firmware, if you can recompile your marlin firmware, you will know how to change it as well I'm assuming. 

CAUTION!
This mount & probe will change your Z offset! Be careful at first print to not scratch your bed and adjust your Z offset first!
Please use PROBE_CALIBRATE command to do so.

For Klipper I've used these settings:

[bltouch]
sensor_pin: PA6
control_pin: PA7
x_offset: 33
y_offset: -21
z_offset: 0
samples: 3
samples_result: median
samples_tolerance: 0.01
samples_tolerance_retries: 5

I also had to change bed_mesh min and max points:

[bed_mesh]
speed: 175
mesh_min: 35, 10
mesh_max: 280, 280
probe_count: 8,8
mesh_pps: 2, 2
algorithm: bicubic
bicubic_tension: 0.1

Enjoy.