Backpack Hook for UPLIFT Desk 4-Leg Standing Desk

Couldn't find a backpack hook I liked that integrated well with my new desk. Wasn't a fan of the clamp-on hooks, or the hooks/hangers that required drilling into the top. Came across another hook that utilized the two holes for the logo plates on Uplift Desks, but it was for another frame. Quickly made this to work with the UPLIFT desk model I have at home and at work, which is the UPLIFT Standing Desk 4-Leg. 

I modeled it to work with a few backpacks I own: 

• Mission Workshop Fraction: AP
• Mission Workshop The Integer
• GORUCK GR1 (21L)

This hook replaces the UPLIFT desk nameplate on either side of the frame. The nameplate just pops off, exposing two 0.190"/4.826mm non-threaded holes. 

I've been using this hook on my desk at home and at work since May of '23. I've hung some relatively heavy backpack loadouts on both of them and neither one has flinched from the weight. 

Hardware: 

• (2x) #10-24x1/2" Socket Head Screws
• (2x) #10-24 Hex Nuts
• (2x) #10 Flat Washers

I used the screws from this screw set, and the nuts and washers from this nut/bolt set. 

Print Settings: 

• Print part with bottom against the build plate
• Material: PETG or ASA
• Nozzle: 0.4mm
• Layer: 0.20mm Structural
• Infill: 40% Gyroid
• Walls: 4
• Supports: No

Install Instructions:

1. Remove UPLIFT nameplate on either side of the frame. It should just pop off if you push on it from the rear.
2. Align holes on the hook with the holes on the frame
3. Insert screws through the holes from the front
4. Thread on washers and nuts on the rear
5. Tighten down both screws