1 / 4
Ultrasonics mount (HC-SR04 to SG-90) — zdjęcie 1
1 / 4

Ultrasonics mount (HC-SR04 to SG-90)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple 90* degree mount desined to fix the HC-SR04 Ultrasonics sensor to the 90* degree Servo SG-90.

Ocena
5 / 5
Polubienia
15
Pobrania
388
Wydruki
1
Wyświetlenia
1088
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This is a printable design to mount the HC-SR04 ultrasonics sensor to the Micro SG-90

To make this design work you'll need four small screws (or two - for each opposing corner) to mount the ultrasonics sensor to the print. And you'll need the 90* degree half mount plastic tab that comes with the SG-90.

The pentagonal hole between the two ultrasonics Holes is designed so the user can clearly see the four markings on the sensor (VCC, GND, TRIG, ECHO), meaning the pins must be on the top side of the mount.

Print in:

  • 0.2mm layer height
  • 10-15% infill

 

Tagi