1 / 2
Tweezers for magnets — zdjęcie 1
1 / 2

Tweezers for magnets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One simple | One overengineered | Fits 5mm magnets

Ocena
5 / 5
Polubienia
10
Pobrania
46
Wydruki
0
Wyświetlenia
423
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Recently I struggled to insert 5mm magnets into my print.

It is doable, but so much hassle, especially if it flips and u lose which side was the right one, especially when you have connecting parts.

I designed print-in-place tweezers, where you can glue one magnet to the top side, and the bottom will always be reserved for another magnet that has the same polarity!

Tip: You can print 2, and add + and - on top in case you need both polarities!
(If requested or if it becomes popular I can expand the type of magnets it holds)

To print this, make sure to have support enabled, the rotating part should come loose with a light squeeze if it's not already loose.

You will need 1 pen spring.

 

  • Simple version, I recommend to print with 1.5mm wall
  • Simple version, print with brim

Tagi