1 / 6
29mm Motor Mount for 3-inch Body Tube — zdjęcie 1
1 / 6

29mm Motor Mount for 3-inch Body Tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified for 3-inch body tube

Ocena
0 / 5
Polubienia
7
Pobrania
67
Wydruki
1
Wyświetlenia
392
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Update: 7/21/2023 - I flew my SpiderMax that is equipped with this motor tube and the fins linked below on 7/15/2023 on an H210 Aerotech RMS motor.   You can see for yourself that this is a very reliable design.  Having the ability to lock the fins in place precisely, nearly eliminated the spin.  The flight was simply spectacular.  I will note that even at 20% infill, this is heavy compared with straight plywood, but the results were worth it!    

I will be working on a 38mm version.   

--------------------

 Introduction

I remixed this motor mount to see if it would meet my current project needs, and it really came in clutch!

I am building a scratch Big Red Max-type rocket on a 29mm motor platform.  After printing all the parts, I found this and got to work on redesigning the project.  I added a mid-centering ring with notches for my fin tab cutouts.  I expanded the top and bottom centering rings to match the middle (73.15mm) and finally opened the motor tube up to accept a 29mm motor mount tube to act as a heat sleeve.  The trickiest part of this was cutting the tube slots for the fins. I tested the motor sleeve and it fits perfectly.  This gives me a couple of options.

  1. I can use the included retaining ring that is included (it was resized as well).  I just need to glue it to the mount and flush-cut it at the aft end of the mount
  2. Add an aeropak-style retaining system.  I prefer this method and include them on all my rockets.  This requires extending the heat sleeve a few millimeters to accommodate the threaded sleeve that gets epoxied to the heat sleeve.

For convenience, I also added a 6.3mm round hole and a 3mm x 15mm rectangular hole on the forward centering ring for shock cord mounting.

Everything else is locked into place and once I have epoxy on all the parts, it's not going anywhere but up!  The pictures should provide some guidance but if you have questions, reach out to me. I added a printout of the fin dimensions for reference.

The fins that fit this motor mount can be found here: 3-inch Big Red Max Fin and Centering Rings

Tagi