Ultimaker Short Belt Tensioner & Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Mooncactus' and Jelle's Ultimaker Original short belt tensioner.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 333
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a remix of Mooncactus' and Jelle's Ultimaker Original short belt tensioner. I've moved it to the inside of the machine, with a full spacing of 11mm (someone replaced my wooden spacer with 10mm plastic spacers which wore away at the belt).
For fitting the parts to the printer you'll need four extra M3 bolts:
2x M3x16 (pull bolt)
2x M3x10 (through wall)
I used 4 rings and didn't fit a spring, see attached pictures.
There's one caveat: you'll need to saw a slot in the back of your machine to allow the y+ endstop cable to pass through (I didnt want mine pushing against the stepper motor).
Print instructions
I printed the part with supports, but with proper bridging it should print without.
Settings: I printed with 2mm walls, top and bottom, 20% fill.