Prusa MK3 / MK3S / MK3S+ LCD cable clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's specifically designed not to wiggle, as pre-existing LCD cable clips for the MK3(S) did and thus were…
- Ocena
- 4,956 / 5
- Polubienia
- 265
- Pobrania
- 1284
- Wydruki
- 43
- Wyświetlenia
- 6129
- Oceny
- 45
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v3.0
It's specifically designed not to wiggle, as pre-existing LCD cable clips for the MK3(S) did and thus were unsatisfactory to me.
The opening of the "hook" should point down for a clean look and easy insertion of the LCD-cable.
If this helps you out, please like, rate and/or share a picture of the result! Otherwise, please leave a comment with feedback 😉
Credits
This is a remix of the 2020 V-Slot LCD-cable clips that have been developed for the Bear-upgrade by Grégoire Saunier.
It has been adapted for compatibility with the 3030 T-Slot extrusion as found on the MK3(S).
Print instructions
Since I specifically made them not to wiggle, they have been designed to be a good, but tight fit. I recommend that your extruder is calibrated for the filament you use, since overextrusion could make it too tight.