voron 2.4 Z endstop pin cap for reliable Z home
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
to make voron 2.4 Z home result value always reliable and accurate
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 1112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
put it on Voron 2.4 's Z stop pin, the pin touches the hidden micro switch, so to make the pin higher, so the pin can correctly touch the omron probe in the tool head (omron TL-Q5M or alike), since the probe is slightly higher than the nozzle.
of course, the end z stop must move back about 2-3cm, since the omron probe is quite large, it's difficult to miss.
After this use mod, the printer must run the whole Z Offset Adjustment process (using a paper to run the command Z_ENDSTOP_CALIBRATE ) to find the correct Z offset value: position_endstop in the printer.cfg file.
https://docs.vorondesign.com/build/startup/ Z Offset Adjustment
I provided 4 version of the caps, they have different top thickness, so hopefully will fit your setup (depends on how high you mount your omron probe).
I use 2.8mm version.
the thickness shouldn't be too picky, because Omron probe has a probe range of 0-4mm
you obviously can't mount it 0mm (hit the bed), so most likely the range is about 1.xx to 3.xxmm.
so I think a 2.8mm thick cap should fit most cases.
print:
use ABS to better handle the higher temperature in chamber.
40%