3 hook paint booth gantry
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This gantry allows me to apply fill and clear coat on lures that I am working on.
- Ocena
- 0 / 5
- Polubienia
- 45
- Pobrania
- 159
- Wydruki
- 0
- Wyświetlenia
- 1174
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This gantry allows me to apply fill and clear coat on lures that I am working on. If you need to do bulk type operations on parts that can hang, while spinning on a turn table or such, this might be helpful for you too.
Print instructions
Print the two large frames (they are identical.)
The cross bar with the J hooks on it could use a 3mm brim. As loaded, the model will print, but the cross bar tends to warp due to it's round profile on the main bar. I got a full print of all three parts out of it and bent the bar back while it was still warm. Advise to print the cross bar separate, or add a brim and print all three.
Comes out fine in 3mm draft - it's not art work after all.
Once printed, use a file and coax the rounded ends on the cross bar into the rounded holes. For smaller or rounder-hooks, I used a file to streamline the J hooks before final assembly.