Clamping Desk Drink Holder - Wine, Yeti, Soda, etc
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Desk drink holder for various bottle sizes that tightens using a threaded screw and 10mm hex key
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 112
- Wydruki
- 1
- Wyświetlenia
- 960
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Finally a drink holder that will last you for years to come!
- Adjustable between desk thicknesses of ~0.125-1.75 inches (3-45 mm)
- Securely tightens with a printable 10 mm hex key
- Fits small soda cans to full-size wine bottles
- Minimal contact to prevent heat transfer
Prints at 20% infill but I recommend at least 50%, especially if you expect to use wine bottles. Perimeters can be 2 and all other settings normal.
Recommend using manual paint supports for the top overhang on the body - see photo. I removed the interface layer and rotated the bridging infill to 90° so it goes across.
If you encounter any issues, just let me know and I'll get to work! I've tested a few prototypes already so you should be good to go!