LM8UU / LM10UU Lubricator for Luer Lok Syringes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lubricant applicator for LM8UU / LM10UU linear bearings. Luer / Luer Lok interface for syringes at the back.
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 188
- Wydruki
- 2
- Wyświetlenia
- 1019
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v3.0
Lubricant applicator for LM8UU / LM10UU linear bearings (8 mm / 10 mm nominal inner diameter).
Luer / Luer Lok interface for syringes at the back.
can be printed without supports. 0.2 mm layer height recommended for best printing of the small holes (0.6 mm height = 3 layers).
Fits on every syringe with a "Luer" taper or “Luer Lok” tip (e.g. "Braun Omnifix 10ml").
A similar item is shipped with the Prusa MK4 kits to screw on to the tube of lubricant.
Just fill a syringe (can be purchased very cheap from every pharmacy) with your lubricant of choice, mount the applicator in front, insert into bearings, apply lube. For a good example on the amount of lubricant to use, see MK4 assembly manual: https://help.prusa3d.com/guide/3-x-axis-x-carriage-assembly_429986#442426